Olympus BX60 Instructions Manual - Page 22

Browse online or download pdf Instructions Manual for Microscope Olympus BX60. Olympus BX60 48 pages. System microscope
Also for Olympus BX60: Quick Start Manual (4 pages)

Print Page

I Utlng Built-in Fillers

I Using the Filter Cosaetto

BX60

(Fig. 25)

Three fitters are built into tha base of the microscope. These filters

can be engaged and disengaged using the levers located on the right

side of the base.

Each of tha three Hters Q to <$ can be engaged (IN) by turning its

lever so that the • mark on the lever is aligned with the • mark on tha

base. It can be dsengaged(OUT) by turning its lever so that the o mark

is aligned with the o mark on the base.

O Each of tha three filters can be switched IN and OUT independently

of the others.

(Figs. 26. 27. 28. 291

I Loading Fitters into the Fitter Housing (Fig. 27) |

O The filter housing accommodates filters wHh a diameter of 45 mm and.

a thickness of 2.7 mm or less.

0 The filter housing has two filter levers en tha right side and one on tfta

left side.

1. Move all filter levers to the OUT position except for the one belonging

to the slot into which the filter is to be inserted.

2. Slide lever 0 to the IN position. Make sure that it clicks securety into

place. (Fig. 26)

3. Holding the lever in the position shown, put the filter into tha cassette

by inserting it in the direction indicated by tha arrow.

4. insert the other (wo filters in the same manner.

1 Mounting the Filter Housing

(Figs. 27. 28

1. Fully loosen the filter cassette clamping screw ®. (Fig. 28)

with the slot @ and snap the filter housing into place from above.

3. Rotate the filter housing to align its sides with the base. (Fig. 28)

exit then tighten the screw to fasten the filter cassette.

* Whan the fitter cassette is installed, the stage may hit it when

lowered. Therefore, exercise caution when lowering tha stags

with the fitter cassette installed.