Olympus MX61L Assembly Manual - Page 15

Browse online or download pdf Assembly Manual for Microscope Olympus MX61L. Olympus MX61L 49 pages. 200mm/300mm compatible semiconductor/fpd inspection microscopes

Print Page

2-2 Detailed Assembly Procedures

!The system contains motorized parts. Do not plug in the power cord until all of the assembly procedures have

completed.

Fig. 4

Fig. 5

Fig. 6

Attaching the Stage

1. Using the Allen wrench (3 mm), remove the transport clamping plate @

from the rear edge of the stage. (Fig. 5) The removed screws should be

used to clamp the stage when attaching it.

}With the MX-SIC6R2/SIC6A, the mounting screw holes are invisible un-

less the upper stage is displaced. It is therefore necessary to remove the

transport clamping plates from the front and rear of the stage.

# Two transport protection sheets are placed in the gaps of the MX-

SIC6A/SIC6R2/SIC8R stage. Be sure to remove them before using

the system.

2. While holding the stage so that the coarse adjustment grip and X-axis/

Y-axis knobs are on the right, gently place the stage on the stage holder

². Using the Allen screwdriver or Allen wrench, tighten the four screws

temporarily.

3. Remove the transport clamping plate(s) from the front ³ and side (MX-

SIC1412R2 only) | of the stage, move it to the rearmost position and,

after confirming that the stage and arm do not interfere with each other,

tighten the four screws firmly. (Fig. 5)

# The clutch and belt may stick together and prevent smooth operation

of the release function if the stage has not been moved for a long

time. If this phenomenon occurs, take the remedial action described

in page 22 in the instruction manual.

Attaching the Y-Stroke Limit Stopper (Fig. 6)

}When the MX-SIC1412R2 stage is used in transmitted light observation

(possible only when the MX-TILLA is used), it is required to attach this

stopper for limiting the Y-axis stroke to 10 inches in order to prevent

interference between the stage and the projected part of the condenser.

1. Place the stage upside down and remove both transport clamping plates.

2. Move the stage and insert the stopper, provided with the stage, into the

two stopper holes ƒ on the center stage.

3. Attach only the front transport clamping plate and then attach the stage.

Caution Before Transporting the Stage (Fig. 5)

Before transporting the stage, be sure to attach the transport clamping

plates @³| and package the stage carefully. Do not transport the stage

when it is attached to the microscope frame or inadequately packaged.

Otherwise, the stage will be damaged.

MX61/MX61L

(Figs. 4 & 5)