Olympus U-LGPS Instructions Manual - Page 17

Browse online or download pdf Instructions Manual for Microscope Olympus U-LGPS. Olympus U-LGPS 24 pages. Led and ldp light source

Print Page

3 3

Troubleshooting

This section describes the possible problems of this product and their remedies.

If problems occur, please review the following list and take remedial action as needed.

If you cannot solve the problem after checking the entire list, contact Olympus for assistance.

Phenomena

Even though the power switch is

set to (ON), the pilot lamp does

not turn ON.

The pilot lamp does not turn ON by

pressing the lamp switch.

The lamp is too bright.

The pilot lamp is blue, but the light

from the lamp does not illuminate

the sample.

The lamp is too dark.

The lamp does not turn ON.

The U-LGPS control software in use

stopped.

The liquid light guide cannot be

attached to U-LGPS or U-LLGAD.

Repair request

If you cannot solve the problems even though taking actions described in Troubleshooting, please contact Olympus

for assistance. At that time, please tell them the following information as well.

· Product name and abbreviation (Example: U-LGPS)

· Serial Number

· Phenomena or strings displayed on the counter on the front of U-LGPS.

Cause

The power cord is not connected

properly.

The power cord plug is not

connected properly.

The fuse is blown out.

The power switch is set to

–

The shutter is in the light path of

the microscope frame.

The liquid light guide is not

attached to the U-LLGAD properly.

Or U-LLGAD is not attached to the

illuminator of the microscope frame

properly.

The pilot lamp is green.

–

The liquid light guide other than

the conformable liquid light guide

is used.

Remedy

Connect the power cord properly.

Connect the power cord plug

properly.

Replace the fuse with a new one.

(OFF). Set the power switch to (ON).

Insert the optical element in the

light path of the microscope frame

to adjust the brightness.

For details, refer to the instruction

manual for the microscope frame

you use.

Remove the shutter from the light

path.

For details, refer to the instruction

manual for the microscope frame

you use.

Connect them properly.

Press the lamp switch to make the

pilot lamp blue.

Set the power switch to

Then, turn ON the lamp.

Use the conformable liquid light

guide.

U-LGPS

Page

(OFF).