Olympus U-LGPS Instructions Manual - Page 19

Browse online or download pdf Instructions Manual for Microscope Olympus U-LGPS. Olympus U-LGPS 24 pages. Led and ldp light source

Print Page

5 5

Assembly

This section describes the procedures to assemble U-LLG150/U-LLG150 and power cords.

Hold the incidence side connector A of U-LLG150/U-LLG300 with

hand, and insert it completely to the end of the liquid light guide

insertion port of U-LGPS.

Loosen the clamping screws B C of U-LLGAD using the Allen

screwdriver provided with the microscope.

If the clamping screws B C are not fully loosened, the tip

TIP

of the emission side connector D contacts the clamping

screws B C and the emission side connector may not be

inserted to the correct position.

Insert the emission side connector D of U-LLG150/U-LLG300

completely to the end of the liquid light guide insertion port of

U-LLGAD.

Tighten the clamping screws B firmly using the Allen screwdriver

provided with the microscope.

Pull the emission side connector D toward you to make sure

TIP

that it does not come out.

Tighten the clamping screws C firmly using the Allen screwdriver

provided with the microscope.

If the clamping screws B C are not tightened firmly,

WARNING

U-LLG150/U-LLG300 may come off from U-LLGAD and a

fire may be caused.

Attach U-LLGAD to the illuminator.

Tighten the clamping screw E of the illuminator using the Allen

screwdriver provided with the microscope.

Do not turn ON the lamp while U-LGPS is not attached to

WARNING

the microscope using U-LLG150/U-LLG300 and U-LLGAD.

The light from this lamp contains the UV light. Looking

directly at the light may damage your eyes. Also, it could

cause a fire.

U-LLG150/U-LLG300 and power cords are vulnerable to

NOTE

bending and twisting. Be careful not to apply excessive

force.

U-LGPS