Olympus U-RFL-T Instruction Manual - Page 11
Browse online or download pdf Instruction Manual for Microscope Olympus U-RFL-T. Olympus U-RFL-T 16 pages.
Also for Olympus U-RFL-T: Instructions Manual (36 pages), Instructions Manual (16 pages)
Print Page
- 1. Power Supply Unit
- 1. 1 Nomenclature
- 2. Safety Precautions
- 2. 2 Assembly
- 2. Assembly Diagram
- 2. Mounting the Mercury Burner
- 2. Cable and Cord Connections
- 3. Table of Contents
- 3. 3 Preparation for Observation
- 3. Igniting the Mercury Burner
- 3. Centering the Mercury Burner
- 4. 4 Specifications
- 5. 5 Troubleshooting Guide
- 5. Proper Selection of the Power Supply Cord
TROUBLESHOOTING GUIDE
Under certain conditions, performance of this unit may be adversely affected by factors other than defects. If problems occur,
please review the following list and take remedial action as appropriate. If you cannot solve the problem after checking the entire
list, please contact your local Olympus representative for assistance.
Problem
a. The main switch LED does not
light.
b. Main switch indicator lights,
but the mercury burner
does not ignite.
c. The burner flickers or is dark.
Cause
The power cord is not connected.
Improperly connected connectors.
The burner is not installed.
The lamp housing interlock
mechanism is activated.
Auto ignition is malfunctioning.
Insufficient time has elapsed since
the burner was turned on.
The burner life has expired.
Remedy
Connect the power cord correctly.
Connect correctly.
Install the burner.
Tighten the burner socket clamping screw.
Turn the main switch on the power supply
to "O" (OFF). Turn to "I" (ON) again.
(Repeat as necessary.)
Wait for 10 minutes after turning on the
burner.
Replace the mercury burner when the
hour counter reading exceeds 200 hours
(USH102D) or 300 hours (HBO103W/2).
U-RFL-T
6