Olympus U-RFL-T Instruction Manual - Page 8

Browse online or download pdf Instruction Manual for Microscope Olympus U-RFL-T. Olympus U-RFL-T 16 pages.
Also for Olympus U-RFL-T: Instructions Manual (36 pages), Instructions Manual (16 pages)

Print Page

2-3 Cable and Cord Connections

Fig. 5

...

Fig. 6

Fig. 7

Fig. 8

Cords are vulnerable when bent or twisted. Never subject them

to excessive force.

Make sure that the main switch is set to "O" (OFF) before

connecting cords and cables.

1. Verify that the voltage and frequency of the AC mains outlet match the

requirements indicated on the rating plate @ on the power supply unit.

(Fig. 5)

2. Plug the mercury burner socket connecting cord plug ² firmly into the

output connector ³. (Fig. 5)

Always use the power cord provided by Olympus. If no power

cord is provided, please select the proper power cord by refer-

ring to the section "PROPER SELECTION OF THE POWER SUPPLY

CORD" at the end of this instruction manual. If the proper power

cord is not used, Olympus can no longer warrant the electrical

safety and performance of the equipment.

3. Plug the power cord connector | into the AC receptacle ƒ. (Fig. 5)

4. Plug the power cord plug ... into a wall outlet. (Fig. 6)

Connect the power cord correctly and ensure that the ground

terminal of the power supply unit and that of the wall outlet are

properly connected. If the equipment is not grounded, Olympus

can no longer warrant the electrical safety and performance of

the equipment. When installing the power cord, route the power

cord away from the lamp housing. Should the power cord come

in contact with the hot lamp housing, the power cord could melt

and cause electric shock.

Set up cords sufficiently away from the lamp housing. Otherwise

cord covering may melt, posing a risk of electric shock.

Resetting the Burner Life Time Hour Counter

1. To reset the burner life time counter to "000.0", press the center portion ²

of the reset button @ on the power supply unit's front panel.

} The counter shows elapsed time in hours. In order not to impair the safety

of the equipment, replace the burner when the counter indicates "200.0"

hours (USH102D) or "300.0" hours (HBO103W/2). Before replacing the

burner, wait at least 10 minutes after turning the burner off.

The mercury burner contains high-pressured gas and it may

crack if used beyond the specified life time.

(Figs. 7, 8)