Olympus PT-E03 Instruction Manual - Page 13

Browse online or download pdf Instruction Manual for Camera Accessories Olympus PT-E03. Olympus PT-E03 41 pages. Underwater case for digital camera e-410/e-400

Print Page

Removing the TTL cable connector cap

To perform TTL flash shooting in combination with the separately available Electronic Flash Case,

remove the TTL cable connector cap as described below.

1 Remove the TTL cable connector cap

from the Case.

2 Connect the Electronic Flash Case's

underwater TTL cable to the TTL

connector on the Case.

How to attach the TTL cable connector cap to the case

Make sure there is no foreign matter attached to the O-rings inside the cap and on the TTL cable

connector. To secure the cap, gently turn it clockwise until it stops.

Check O-rings

Cap

CAUTION:

If the TTL cable connector cap is loose, water penetration may result. Be sure to gently turn the cap until it

stops to make sure it is firmly secured.

Do not turn or tighten the TTL cable too hard. If it is too tight, it may be difficult to loosen and remove.

* For details on the TTL cable and hot shoe cable, refer to the instruction manual provided with the Electronic

Flash Case.

TTL cable connector

cap

1 Turn counter

clockwise.

3 Insert into the

connector.

4 Turn the threaded

section of the

connector clockwise

lightly until it stops.

1 Attach the cap to

the case.

Connector

2 Remove.

Underwater TTL

cable

Use this mark to

align the position.

2 Gently turn the cap

clockwise until it

stops.

EN 12