Olympus PT-E03 Інструкція з експлуатації - Сторінка 13
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Аксесуари для фотоапаратів Olympus PT-E03. Olympus PT-E03 41 сторінка. Underwater case for digital camera e-410/e-400
Друкувати сторінкуRemoving the TTL cable connector cap
To perform TTL flash shooting in combination with the separately available Electronic Flash Case,
remove the TTL cable connector cap as described below.
1 Remove the TTL cable connector cap
from the Case.
2 Connect the Electronic Flash Case's
underwater TTL cable to the TTL
connector on the Case.
How to attach the TTL cable connector cap to the case
Make sure there is no foreign matter attached to the O-rings inside the cap and on the TTL cable
connector. To secure the cap, gently turn it clockwise until it stops.
Check O-rings
Cap
CAUTION:
If the TTL cable connector cap is loose, water penetration may result. Be sure to gently turn the cap until it
stops to make sure it is firmly secured.
Do not turn or tighten the TTL cable too hard. If it is too tight, it may be difficult to loosen and remove.
* For details on the TTL cable and hot shoe cable, refer to the instruction manual provided with the Electronic
Flash Case.
TTL cable connector
cap
1 Turn counter
clockwise.
3 Insert into the
connector.
4 Turn the threaded
section of the
connector clockwise
lightly until it stops.
1 Attach the cap to
the case.
Connector
2 Remove.
Underwater TTL
cable
Use this mark to
align the position.
2 Gently turn the cap
clockwise until it
stops.
EN 12
En