AccuMed AP212 User Manual - Page 6

Browse online or download pdf User Manual for Pulse Generator AccuMed AP212. AccuMed AP212 15 pages. Mini electronic pulse stimulator

Print Page
DEVICE OPERATION OVERVIEW:
1
2
4
5
OPERATE DEVICE:
1.
The AP212 unit needs to be charged for up to 10 hours before the initial use.
2.
Make sure the power switch of the device is in the OFF position.
3.
Connect a pair of electrode pads to one lead wire by snapping them on.
•
Connect the other end of the lead wire to the left output of the device.
•
Snap the other pair of electrode pads to the remaining lead wire and the right output of the device.
4.
Use a damp towel or wet wipe to clean skin of treatment area. Remove the protective film from the electrode pad and
attach to treatment area. Ensure both pads are on the skin and not overlapping.
5.
Turn on the unit by sliding the On/Off switch from Off to On.
6.
Once On, the device will automatically enter Mode 1 (Massage I). The Timer will default to 20 minutes.
ADJUST INTENSITY:
Press the AB Button to change between channels. The intensity can be adjusted while the "A" or "B" flashes on the
1.
screen which indicates the channel you are in.
2.
Press the "+" button to increase the intensity.
3.
Press the "-" button to decrease the intensity.
CHANGE MODES:
1.
The device will automatically enter Mode 1 Variation I when turned on. Press the Play/Pause button to access the next
variation in the main illustrated mode.
2.
Press the Play/Pause button to access the next variation within the same mode.
3.
Press the M button to cycle through the 6 illustrated main stimulation modes.
ADJUST TIMING:
1.
hold the play/pause button for 2-3 seconds. The time will increase by 10 minutes each time. After the time runs out the
device turns off automatically, and it can be restarted if treatment needs to be continued.

TWO KEY POINTS FOR OPERATIONS:

1.
Locate the exact location of the pain: Apply the pads (electrodes) to the muscle area where you are experiencing pain,
stiffness, or soreness.
2.
Intensity: The intensity should be gradually increased until you reach the highest setting before it becomes
uncomfortable.
1)
LCD Screen
2)
Mode Selector
3)
Play/Pause Button
4)
Intensity Adjuster
(Increase/Decrease)
5)
AB Button
3
6