Cino XS speedmix H5 Operating Manual - Page 9

Browse online or download pdf Operating Manual for Coffee Maker Cino XS speedmix H5. Cino XS speedmix H5 20 pages.

Print Page

Version FXSHD 12A onwards

Clean-Set XS H5

29.12.2003

XS Speedmix H3

2. Cleaning instructions

Monthly cleaning

Steps for the daily and weekly cleaning described under section

1 to 7 are included here.

8. Clean the product container: First of all close the red shut-

off flaps on the product containers. Take out the product

containers by lifting these slightly at the front and then pulling

them out. Pour out the remaining product. Remove the product

chutes from the product containers. Put the product containers

and chutes in a rinsing solution meant for them. Wipe the

product containers clean with the help of a sponge. Dry out the

product containers properly. Preferably leave them to dry out

overnight and install them again next day and fill in.

9. Clean fan duct: When you have taken out the product

containers and the mixing bowls, you can pull out the plastic

drawer above the mixing bowls and below the product

containers. This is meant to be the suction channel for water

vapour suction. Here it is possible that the product also gets

sucked along. Clean the fan duct using the rinsing solution

meant for the purpose and dry it up properly before

reinstallation.

Cleaning aids

Use the Clean Set specially prepared for the machine . (Clean

Set for XS H5)

The Clean SET allows quick and easy cleaning of the machine.

The Cleans Set consists of:

- Pre-assembled mixing bowl and outlet pipe for coffee

- Pre-assembled mixing bowl and outlet pipe for cocoa

- Pre-assembled outlet pipe for water meant for tea

- Right product chute for coffee

- Right product chute for cocoa

- Left product chute for milk

- 6 mm cleaning brush for discharge angle

- 10 mm cleaning brush for outlet pipe 9 x 6

- 5 Litre cleaning bucket

- Yellow sponge cloth

- Scratch-free sponge

- HACCP cleaner, diluted and ready for use.

Procedure

Perform steps as in case of daily, weekly and monthly cleaning.

Using the Clean Set you can immediately replace these parts

placed in a rinsing solution. The machine again becomes

immediately operational. The replaced parts should then be

sprayed with the HACCP cleaner and must be placed in a

rinsing solution diluted with the HCCP. After reaction time of

approximately 45 minutes you can rub off these parts with a

sponge cloth, rinse them under clear water and allow to dry up

well.

For your machine you can order as follows:

Clean Set XS H5 Item number: 100 542

Operating manual

2.4

2.5

! ! ! !

Remember that:

Cleaning with our

Clean Sets is:

- quicker

and simpler

- fresher and

more appetizing

- more hygienic, and

causes lesser

malfunctions

! ! ! !

With the aid of Clean

Sets you easily

replace fouled parts.

The machine again

becomes immediately

operational.