ARCBRO Thunder X-PRO Service Support - Page 2

Browse online or download pdf Service Support for Industrial Equipment ARCBRO Thunder X-PRO. ARCBRO Thunder X-PRO 7 pages. How to set flame cutting - debugging process

Print Page

Service Support Spirit

Step 1-2 : Press the 【F4 Setups】 key at the cutting interface→Into Parameter interface; →

Press the 【F2 Flame】; Need to change two parameter;

--Low Preheat Time

steel plate increases, the Preheat time increases.}

--Pierce 1 Time

of the steel plate increases, the Pierce time increases.}

Note: This time is based on the actual situation on site.



Step 2- Manual test flame cutting;{ We use oxygen+ acetylene as an example}

Step 2-1 : Connect acetylene and oxygen to the gas pipeline of the machine - red for gas pipeline

and blue for oxygen pipeline；

Unique Solution

100.00S{This is the Preheat time of the flame. As the thickness of the

01.50S{ This is the Pierce time of the flame cutting. As the thickness

Pic2

Change to 100S

Change to 01.50S