Arcflash Labs SGP-34 User Manual - Page 10
Browse online or download pdf User Manual for Industrial Equipment Arcflash Labs SGP-34. Arcflash Labs SGP-34 13 pages. Single stage scr coilgun
Print Page2.6 Trigger
- Do not exert excessive pressure on the trigger. It is a fragile component.
The trigger of the SGP-34 is connected to a small microswitch internally and is actuated
by a small spring. The trigger only has roughly 0.06" of travel length and the spring return is
very fragile. If excessive pressure is exerted on the trigger, the spring return could detach. If
this occurs, discontinue use of the gun and immediately return to the manufacturer for repairs.
If further pressure is exerted on the trigger, damage to the microswitch and/or main control
board could result.
2.7 Magazine
The SGP-34 uses a proprietary 18 round magazine design based loosely off of the MG20.
Similar to the MG20, it uses a constant force spring and accepts Arcflash Labs 2575 magnetic
armatures. The SGP-34 is NOT compatible with the MG series of magazines. To order a
replacement or extra magazine, please contact Arcflash Labs directly at
2.8 Capacitors
- The SGP-34 contains one large 1500uF capacitor capable of storing over 150J of energy.
The SGP-34 contains one large electrolytic capacitor (1,500 uF total capacitance). It is
capable of delivering over 1000A burst current at 450V and storing over 150J of energy.
The capacitors remain charged for approximately TEN SECONDS after disconnecting all
power from the gun. During this time, the gun may still fire. To power down the gun we
recommend the following procedure: 1) set the main switch to the off position, ensuring the
green power light is not active, 2) remove the magazine from the gun, verify that there is no
round still remaining in the barrel, and 3) wait approximately 10 seconds before removing the
battery.
The red LED near the barrel indicates the state of charge on the capacitor. If the red LED
is illuminated, the capacitor is fully charged.
.
10 |
P a g e