Accuris E2301 Series Operating Manual - Page 4

Browse online or download pdf Operating Manual for Power Supply Accuris E2301 Series. Accuris E2301 Series 6 pages. 300v power supply

Print Page

2. Product Overview

In CONSTANT CURRENT mode, the power supply will output

4 Pairs of

the set mAmp current parameter, and the voltage will fluctuate

Touch Screen

Electrical Outputs

relative to the resistance of the load (buffer concentration in the

Control and Display

attached electrophoresis tanks) up to a maximum of the voltage

setting that has been chosen.

FRONT

6.4 Automatic Cross Over

During an electrophoresis run, the power supply will attempt to

maintain the constant voltage or amperage setting, depending on

which parameter is set to "CONSTANT".

If, during a run, the non-constant parameter setting (limit) is met

due to the resistance of the load, the power supply will

automatically "cross over" so the non-constant parameter will

now be the constant and limiting parameter. A red outline will

appear around the new "constant" value.

6.5 Maximum Power Limit

Folding

Recesses for

Front Feet

Stacking 2 Units

The myVolt Touch Power Supply has a maximum power output

of 100 Watts.

Per Ohms Law:

Power (P) = Current (I) x Voltage (V)

If the maximum power is reached during an electrophoresis run,

the non-constant parameter will be limited to prevent exceeding

the maximum power output

Cooling

CAUTION:

It is not recommended to run the power supply at or

Fan

near the maximum wattage, as this will cause the power supply

and gel tank to get hot. Most standard electrophoresis buffer

concentrations will not have such low resistance that the current

Rating, Serial #

AC Power Inlet

REAR

and voltage level will come close to the maximum power limit.

Label

and Fuse