Cres Cor AquaTemp CO-151-FWUA-12DX2081BC Installation, Operation And Maintenance Manual - Page 7

Browse online or download pdf Installation, Operation And Maintenance Manual for Convection Oven Cres Cor AquaTemp CO-151-FWUA-12DX2081BC. Cres Cor AquaTemp CO-151-FWUA-12DX2081BC 17 pages. Humidity convection ovens

Print Page

Convection

FL-2373-BC

Humidity Oven

Page 7 of 17

Rev. 1 (8/20)

UNIT OPERATION:

1 . Press power switch ON

2 . Unit will automatically begin preheating recipe 1 .

The screen will show PREHEAT and an Indicator light

by the recipe button will be blinking indicating a recipe

is being run .

a . During PREHEAT, the DISPLAY button can be

pressed to allow the user to see the following

values:

i . "A" actual oven temp

ii . "P" probe actual value

iii . rcP## recipe currently being used

NOTE: To select a different recipe, press RECIPE button,

scroll to desired recipe, and press "PUSH TO

SET" button to save and enter .

3 . To skip the preheat process and begin the cook cycle,

hold START for 3 seconds .

4 . If chosen not to skip preheat, wait for unit to heat to

recipe 1 cook temp .

5 . After oven has reached temperature, one long beep

will be heard, and PUSH START will be displayed on

screen .

6 . Insert meat probe into media and quickly load oven .

7 . Press START to begin the cook cycle . Five long beeps

will be heard and the light next to the COOk button

will flash. Indicator lights next to COOK, PROBE, and

RECIPE buttons will be illuminated .

NOTE: The cook cycle will keep the oven at cook temp

setpoint until probe temp setpoint has been

reached .

Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com

5925 Heisley Road • Mentor, OH 44060-1833

OPERATING INSTRUCTIONS

8 . Control will constantly display probe actual temp "P"

9 . Pressing DISPLAY button will allow user to see the

following values:

a . "t" time of current cycle

b . "s" probe setpoint

c . "A" actual oven temp

d . "H" probe max temp

e . "L" probe min temp

f . rcP## recipe currently being used

NOTE: Probe min and max temps are reset if CANCEL

button is pressed, unit is turned off, or when a

new cook cycle has started .

10 . When probe temp setpoint has been reached, unit will

switch from cook mode to hold mode .

a . If cook cycle has taken longer than 2 hours, a

single beep will be heard .

b . If cook cycle has taken less than 2 hours, 5 long

beeps will be heard and "2 Hr" will be displayed

on the screen . Press DISPLAY button to clear

visual alarm .

NOTE: Min and max probe temps will continue to be

tracked through hold mode .

11 . Default display for hold mode is the screen alternating

between the two displayed parameters:

a . Hold temp setpoint

b . "t" hold time