Cres Cor AquaTemp CO-151-FWUA-12DX2081BC Посібник з монтажу, експлуатації та технічного обслуговування - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник з монтажу, експлуатації та технічного обслуговування для Конвекційна піч Cres Cor AquaTemp CO-151-FWUA-12DX2081BC. Cres Cor AquaTemp CO-151-FWUA-12DX2081BC 17 сторінок. Humidity convection ovens
Друкувати сторінкуConvection
FL-2373-BC
Humidity Oven
Page 7 of 17
Rev. 1 (8/20)
UNIT OPERATION:
1 . Press power switch ON
2 . Unit will automatically begin preheating recipe 1 .
The screen will show PREHEAT and an Indicator light
by the recipe button will be blinking indicating a recipe
is being run .
a . During PREHEAT, the DISPLAY button can be
pressed to allow the user to see the following
values:
i . "A" actual oven temp
ii . "P" probe actual value
iii . rcP## recipe currently being used
NOTE: To select a different recipe, press RECIPE button,
scroll to desired recipe, and press "PUSH TO
SET" button to save and enter .
3 . To skip the preheat process and begin the cook cycle,
hold START for 3 seconds .
4 . If chosen not to skip preheat, wait for unit to heat to
recipe 1 cook temp .
5 . After oven has reached temperature, one long beep
will be heard, and PUSH START will be displayed on
screen .
6 . Insert meat probe into media and quickly load oven .
7 . Press START to begin the cook cycle . Five long beeps
will be heard and the light next to the COOk button
will flash. Indicator lights next to COOK, PROBE, and
RECIPE buttons will be illuminated .
NOTE: The cook cycle will keep the oven at cook temp
setpoint until probe temp setpoint has been
reached .
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING INSTRUCTIONS
8 . Control will constantly display probe actual temp "P"
9 . Pressing DISPLAY button will allow user to see the
following values:
a . "t" time of current cycle
b . "s" probe setpoint
c . "A" actual oven temp
d . "H" probe max temp
e . "L" probe min temp
f . rcP## recipe currently being used
NOTE: Probe min and max temps are reset if CANCEL
button is pressed, unit is turned off, or when a
new cook cycle has started .
10 . When probe temp setpoint has been reached, unit will
switch from cook mode to hold mode .
a . If cook cycle has taken longer than 2 hours, a
single beep will be heard .
b . If cook cycle has taken less than 2 hours, 5 long
beeps will be heard and "2 Hr" will be displayed
on the screen . Press DISPLAY button to clear
visual alarm .
NOTE: Min and max probe temps will continue to be
tracked through hold mode .
11 . Default display for hold mode is the screen alternating
between the two displayed parameters:
a . Hold temp setpoint
b . "t" hold time