Digimax 210 User Manual - Page 8

Browse online or download pdf User Manual for Thermostat Digimax 210. Digimax 210 11 pages. Programmable thermostat compatible with maxi controller
Also for Digimax 210: User Manual (12 pages)

Print Page

b) Installation

1. Set the security console mode switch to the THERM posi-

tion.

2. To install a thermostat with the console, press and hold

its + and - keys together for 3 seconds. The DigiMax 210

will then transmit its unique digital code every 10 seconds

for the next 5 minutes. The display will show flash ']]]'

while this is happening.

3. After a few seconds you should hear a "bip" from the con-

sole and the first zone indicator should come on or, if you

have already intalled thermostats with the console, the

next available free zone will be indicated.

4. Go to the thermostat and press any key to stop the trans-

mission. The display will stop flashing ']]]' and return to

normal.

5. Repeat this procedure for thermostat 2, 3 and 4. The first

thermostat will be installed on zone 1, the second will be

installed on zone 2...., the fourth on zone 4.

6. On the security console, reset the mode switch to Run1 or

Run2

Each thermostat will transmit a message every 5 minutes. If

during 20 minutes, the console does not receive any signal

from a thermostat, its RECORD LED will flash.

You can then put the slide switch to the THERM position to

see which zone (thermostat) has a problem.

The Maxi Controller transmits an X10 message on the unit

code of the zone allocated by the security console (see above)

and on the house code of the console + 1.

i.e. : If the console is on Housecode A,

- thermostat on zone 1 will generate message on code B1,

Page 8