Accusplit Eagle AE170XL Operating Instructions - Page 3

Browse online or download pdf Operating Instructions for Pedometer Accusplit Eagle AE170XL. Accusplit Eagle AE170XL 4 pages. Accusplit fitness electronics user manual

Print Page

Accusplit Eagle AE170XL Operating Instructions

WEARING YOUR PEDOMETER

Gently slide the pedometer

onto your belt or the top

edge of your pants or skirt.

It should fit snugly and

level, above one knee. T he

strong steel clip makes it

easy.

Note: T he pedometer should be as vertical as possible.

Walkers with larger stomachs may find it helpful to

wear the pedometer farther back on the body, toward

one hip.

The cover must be closed for the pedometer to work.

First, loop leash

through slot on side

of pedomete

Next, clasp clothing

Or, loop a belt

or belt loop

RESETTING YOUR PEDOMETER

Most people prefer to reset counts daily. T o reset your counts:

From STEP , DISTANCE, or CALORIE mode, press and hold

the yellow RESET button for at least 2 seconds. Y ou'll see the

values all go back to zero.

Can be set

from 0-5

steps

"US" (English)

or "EU" (Metric)

IGI

ALKER

.COM

STEP

DIST CAL

SET

170

JW200

S3-

S1,S2,S4

S3+

Set measurement mode

yes

Or, loop a

badge holder, then

put into pocket

(Badge holder

not included)

IGI

ALKER

.COM

STEP

DIST CAL

SET

170

JW200

S3-

S1,S2,S4

S3+

Set Step Filter set point

To avoid losing or dropping your pedometer, use the included

leash and clip to fasten the pedometer securely to your

clothing.

Attaching the Leash

1. Attach the pedometer to the leash by looping the thin

side of the leash through one of the leash slots on the

sides of the pedometer case, near the bottom of the unit.

2. Put the pedometer onto your clothing as discussed above.

3. Attach the alligator clip to a belt loop or the top edge of the

pants or skirt.

Note: Y ou can also use a safety pin to fasten the leash to

your clothing, loop the leash through your belt or belt

loop, or use a badge holder.

VIEWING YOUR RESULTS

Once you put on your pedometer with the cover closed, it

will automatically begin to record your steps, activity time,

distance, and calories burned. Repeatedly press the MODE

button to cycle through the pedometer modes:

STEPS g DISTANCE g CALORIE g STEPS

Distance and Calories are counted automatically whenever

steps are being counted.

• DISTANCE is simply stride length x steps.

• CALORIES is calorie burn from activity based on

your weight and rate of stepping pace.

Note: For extra accuracy, the default Step Filter Setting is 1.

See page 21 to learn more.

OTHER SETTINGS

The Step Filter and Unit of Measurement settings are

accessed through a special "deep set" mode.

To enter this mode, press and hold the S1 button for 4

seconds. T he screen will display a single digit. From within

Deep Set mode, press the S2 button to cycle back and forth

between the Step Filter set point and Choice of Unit System.

CHANGING STEP FILTER SETTING

While the JW200 PedometerEngine™ Step Sensor is

extremely accurate, some people like to have the ability to

filter out false steps. T herefore, the unit has a variable setting

step filter, to allow fine-tuning to your specific preferences.

You can set the value to any value from 0 – 5 steps. For

example, if the filter is set to "3" , the unit will wait to start

counting steps until more than three steps have been taken in

less than five seconds.

Press S3+ (MODE) or S3– (RESET) to change the Step Filter

Setting.