1
About this Guide
This guide provides instructions on how to use Express Setup to initially configure your Catalyst
switch. Also covered are switch management options, basic rack-mounting procedures, port and
module connections, power connection procedures for both AC- and DC-powered switches, and
troubleshooting help.
For additional installation and configuration information for Long-Reach Ethernet (LRE) switches
and for all switch models, refer to the Catalyst 2950 documentation on Cisco.com. For system
requirements, important notes, limitations, open and resolved bugs, and last-minute documentation
updates, see the release notes, also on Cisco.com.
When using the online publications, refer to the documents that match the Cisco IOS software version
running on the switch. The software version is on the Cisco IOS label on the switch rear panel.
You can order printed copies of the manuals from the Cisco.com sites and from the telephone numbers
listed in the "Obtaining Documentation" section on page 21.
For translations of the warnings that appear in this publication, refer to the Regulatory Compliance
and Safety Information for the Catalyst 2950 Switch that accompanies this guide.
2
Taking Out What You Need
Follow these steps:
1. Unpack and remove the switch and the accessory kit from the shipping box.
2. Return the packing material to the shipping container, and save it for future use.
3. Verify that you have received the items shown on page 3. If any item is missing or damaged,
contact your Cisco representative or reseller for instructions. Some switch models might include
additional items that are not shown on page 3.
Equipment That You Supply to Run Express Setup
You need to supply this equipment to run Express Setup:
• PC
• Ethernet (Category 5) straight-through cable (as shown)
2
Print Page