Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Installation Note - Page 17

Browse online or download pdf Installation Note for Switch Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 28 pages. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Also for Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Installation Note (14 pages), Solution Manual (17 pages), Installation Note (46 pages), White Paper (19 pages), Description (1 pages), Product Bulletin (6 pages), Notice (4 pages), Datasheet (9 pages), Datasheet (18 pages), White Paper (18 pages), Configuration Manual (8 pages), Troubleshooting Manual (11 pages), Installation Note (18 pages), User Manual (17 pages), Installation Note (24 pages), Manual (19 pages), Installation Note (36 pages)

Print Page
Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Installation Note
Figure 4
Note
Tighten the two captive installation screws on the supervisor engine or module.
e.
Note
Vertical slots
Position the supervisor engine or switching module in the slot. (See
a.
align the sides of the switching-module carrier with the slot guides on the top and bottom of the slot.
78-15751-03
Ejector Lever Closure in a Horizontal Slot Chassis
WS-X6K-SU P2-2GE
1
CONSOLE
PORT
MODE
CONSOLE
SUPERVIS OR2
PCMCIA
WS-X6K-SU P2-2GE
2
CONSOLE
PORT
MODE
CONSOLE
SUPERVIS OR2
PCMCIA
3
4
WS-C650 0-SFM
5
SWITCH FABRIC MDL
6
Ejector levers flush
with module faceplate
Failure to fully seat the module in the backplane connector can result in error messages.
Make sure that the ejector levers are fully closed before tightening the captive installation
screws.
Switch
Load
100%
PORT 1
EJECT
1%
Switch
Load
100%
PORT 1
EJECT
1%
Catalyst 6500 Series Switch Content Switching Module Installation Note
Installing the CSM
PORT 2
PORT 2
Figure
5.) Make sure that you
17