Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Вказівки щодо встановлення - Сторінка 17

Переглянути онлайн або завантажити pdf Вказівки щодо встановлення для Перемикач Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 28 сторінок. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Також для Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Вказівки щодо встановлення (14 сторінок), Посібник з розв'язання (17 сторінок), Вказівки щодо встановлення (46 сторінок), Біла книга (19 сторінок), Опис (1 сторінок), Інформаційний бюлетень про продукцію (6 сторінок), Повідомлення (4 сторінок), Технічний паспорт (9 сторінок), Технічний паспорт (18 сторінок), Біла книга (18 сторінок), Посібник з конфігурації (8 сторінок), Посібник з усунення несправностей (11 сторінок), Вказівки щодо встановлення (18 сторінок), Посібник користувача (17 сторінок), Вказівки щодо встановлення (24 сторінок), Посібник (19 сторінок), Вказівки щодо встановлення (36 сторінок)

Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Вказівки щодо встановлення
Figure 4
Note
Tighten the two captive installation screws on the supervisor engine or module.
e.
Note
Vertical slots
Position the supervisor engine or switching module in the slot. (See
a.
align the sides of the switching-module carrier with the slot guides on the top and bottom of the slot.
78-15751-03
Ejector Lever Closure in a Horizontal Slot Chassis
WS-X6K-SU P2-2GE
1
CONSOLE
PORT
MODE
CONSOLE
SUPERVIS OR2
PCMCIA
WS-X6K-SU P2-2GE
2
CONSOLE
PORT
MODE
CONSOLE
SUPERVIS OR2
PCMCIA
3
4
WS-C650 0-SFM
5
SWITCH FABRIC MDL
6
Ejector levers flush
with module faceplate
Failure to fully seat the module in the backplane connector can result in error messages.
Make sure that the ejector levers are fully closed before tightening the captive installation
screws.
Switch
Load
100%
PORT 1
EJECT
1%
Switch
Load
100%
PORT 1
EJECT
1%
Catalyst 6500 Series Switch Content Switching Module Installation Note
Installing the CSM
PORT 2
PORT 2
Figure
5.) Make sure that you
17