Cisco 9134 - MDS Multilayer Fabric Switch Configuration Manual - Page 35

Browse online or download pdf Configuration Manual for Switch Cisco 9134 - MDS Multilayer Fabric Switch. Cisco 9134 - MDS Multilayer Fabric Switch 49 pages. Mds 9000 series
Also for Cisco 9134 - MDS Multilayer Fabric Switch: Specifications (3 pages), Release Note (48 pages), Release Note (44 pages), Release Note (22 pages), Release Note (3 pages), Release Note (40 pages), Release Notes (10 pages), Manual (16 pages), Hardware Installation Manual (36 pages)

Print Page
Cisco 9134 - MDS Multilayer Fabric Switch Configuration Manual
Figure 27 Both C-Series switches are target portals
C-Series switch side: configuring transparent-mode static mapping
The iSCSI-enabled C-Series switches have two modes of mapping IP addresses:
•
Transparent-mode dynamic mapping
•
Transparent-mode static mapping
You must enable static mapping for each iSCSI Initiator for persistent LUN mapping from the Fibre
Channel storage controller.
1.
Using the Cisco Device Manager, select IP > iSCSI from the menu bar.
The IP iSCSI window opens
Figure 28 IP iSCSI window
2.
Clear the Discovery Dynamic check box
(Figure
28).
(Figure
29).
C-Series iSCSI
35