Sharp AR-C260 Key Operator's Manual - Page 12

Browse online or download pdf Key Operator's Manual for All in One Printer Sharp AR-C260. Sharp AR-C260 19 pages. Color adjustment
Also for Sharp AR-C260: Network Scanner Operations (42 pages), Printer Operation Manual (50 pages), Software Installation Manual (25 pages), Color Management Manual (8 pages), Installation Manual (15 pages), User Manual (8 pages)

Print Page

GENERAL PROGRAMS

Saddle stitch position adjust

This program is used to adjust the stapling position

(folding position) when using the saddle stitch

function of the optional saddle stitch finisher.

The value can be adjusted in 0.1 mm increments

within ±3.0 mm from the reference position for

each paper size.

Max. +3 mm

Position adjusted

to the plus

direction

Reference position

[AUTOMATIC SADDLE STITCH] checkmark

The saddle stitch print function can normally be

divided into the following three general steps.

1. The pages of the original are automatically

reordered to allow saddle stitch binding (saddle

stitch function).

2. The pages are folded at the centre.

3. The paper is stapled at the centre in two places

(saddle stitch stapling).

The [AUTOMATIC SADDLE STITCH] checkbox is

selected by default.

Selection of the checkbox assumes the use of the

above saddle stitch printing function (three steps).

Saddle stitch stapling exceptions

Depending on the purpose of saddle stitch

stapling, it may be necessary to perform saddle

stitch stapling on printed matter that has already

been bound by saddle stitching. In this case, it is

necessary to disable step 1 above. If you

frequently perform this type of exceptional saddle

stitch stapling that requires disabling step 1,

remove the checkmark from the [AUTOMATIC

SADDLE STITCH] checkbox.

Min. -3 mm

Position adjusted

to the minus

direction

Stream feeding mode

This program is used to enable the stream feeding

mode of the document feeder. When the stream

feeding mode is enabled, additional originals which

are set in the document feeder tray within 5

seconds after the previous original was fed will be

fed and copied automatically.

NOTE

The stream feeding mode will not function when the

covers mode has been selected.

Auto paper selection setting

Use this program to select the paper type* for

which the automatic paper selection function

operates. Selections are "Plain paper", "Plain

paper and recycle paper", and "Recycle paper".

* The paper type set for each paper tray in the

paper tray settings of the user settings (page 2-11

of the Operation Manual for general information

and copier operation).

Registration adjustment

Use this program when the colour of characters

and lines in colour printing is off. Registration

adjustment can be performed in two ways:

manually and automatically. Normally [AUTO

ADJUSTMENT] should be used.

G [AUTO ADJUSTMENT]

Touch this key to have registration adjustment

performed automatically.

After touching this key, touch the [EXECUTE]

key. A message appears when automatic

registration adjustment is completed. Touch the

[EXIT] key to exit.

G [MANUAL ADJUSTMENT]

Touch

this

key

adjustment manually.

Use this key when you require a higher level of

precision than can be obtained with [AUTO

ADJUSTMENT]. See page 11 for the procedure

for manual registration adjustment.

perform

registration