Sharp AR-C260 주요 운영자 매뉴얼 - 페이지 12
{카테고리_이름} Sharp AR-C260에 대한 주요 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp AR-C260 19 페이지. Color adjustment
Sharp AR-C260에 대해서도 마찬가지입니다: 네트워크 스캐너 운영 (42 페이지), 프린터 사용 설명서 (50 페이지), 소프트웨어 설치 매뉴얼 (25 페이지), 컬러 관리 매뉴얼 (8 페이지), 설치 매뉴얼 (15 페이지), 사용자 설명서 (8 페이지)
페이지 인쇄
GENERAL PROGRAMS
Saddle stitch position adjust
This program is used to adjust the stapling position
(folding position) when using the saddle stitch
function of the optional saddle stitch finisher.
The value can be adjusted in 0.1 mm increments
within ±3.0 mm from the reference position for
each paper size.
Max. +3 mm
Position adjusted
to the plus
direction
1
2
Reference position
[AUTOMATIC SADDLE STITCH] checkmark
The saddle stitch print function can normally be
divided into the following three general steps.
1. The pages of the original are automatically
reordered to allow saddle stitch binding (saddle
stitch function).
2. The pages are folded at the centre.
3. The paper is stapled at the centre in two places
(saddle stitch stapling).
The [AUTOMATIC SADDLE STITCH] checkbox is
selected by default.
Selection of the checkbox assumes the use of the
above saddle stitch printing function (three steps).
Saddle stitch stapling exceptions
Depending on the purpose of saddle stitch
stapling, it may be necessary to perform saddle
stitch stapling on printed matter that has already
been bound by saddle stitching. In this case, it is
necessary to disable step 1 above. If you
frequently perform this type of exceptional saddle
stitch stapling that requires disabling step 1,
remove the checkmark from the [AUTOMATIC
SADDLE STITCH] checkbox.
10
Min. -3 mm
Position adjusted
to the minus
direction
12
11
Stream feeding mode
This program is used to enable the stream feeding
mode of the document feeder. When the stream
feeding mode is enabled, additional originals which
are set in the document feeder tray within 5
seconds after the previous original was fed will be
fed and copied automatically.
NOTE
The stream feeding mode will not function when the
covers mode has been selected.
Auto paper selection setting
Use this program to select the paper type* for
which the automatic paper selection function
operates. Selections are "Plain paper", "Plain
paper and recycle paper", and "Recycle paper".
* The paper type set for each paper tray in the
paper tray settings of the user settings (page 2-11
of the Operation Manual for general information
and copier operation).
Registration adjustment
Use this program when the colour of characters
and lines in colour printing is off. Registration
adjustment can be performed in two ways:
manually and automatically. Normally [AUTO
ADJUSTMENT] should be used.
G [AUTO ADJUSTMENT]
Touch this key to have registration adjustment
performed automatically.
After touching this key, touch the [EXECUTE]
key. A message appears when automatic
registration adjustment is completed. Touch the
[EXIT] key to exit.
G [MANUAL ADJUSTMENT]
Touch
this
key
adjustment manually.
Use this key when you require a higher level of
precision than can be obtained with [AUTO
ADJUSTMENT]. See page 11 for the procedure
for manual registration adjustment.
to
perform
registration