Sharp AR-M351N Key Operator's Manual - Page 17

Browse online or download pdf Key Operator's Manual for All in One Printer Sharp AR-M351N. Sharp AR-M351N 20 pages. Digital printer
Also for Sharp AR-M351N: Brochure & Specs (7 pages)

Print Page

PROGRAMS FOR COPY MODE

Initial margin shift setting

This program is used to set the initial margin shift

amount.

The initial margin shift amount can be set from 0 mm to

20 mm (0" to 1") in increments of 1 mm (1/8").

Normally the margin shift is set to 10 mm (1/2") for both

the front and back of the paper.

Erase width adjustment

This program is used to set the initial width of edge

erase copying.

The edge erase width can be set from 0 mm to 20 mm

(0" to 1") in increments of 1 mm (1/8").

The edge erase and centre erase widths are normally

set to 10 mm (1/2").

Card shot settings

This program is used to set the initial original size for

the card shot function.

Enter the X dimension (width) first and then the Y

dimension (length).

Both the X and Y dimensions can be set from 25 mm to

210 mm (1" to 8-1/2") in increments of 1 mm (1/8").

Setting a maximum number of copies

This program is used to set the maximum number of

copies that are allowed per original.

Any number from 1 to 999 can be set for the maximum.

The maximum number of copies is initially set to 999.

Disabling deletion of job programs

This program is used to prohibit the deletion and

changing of copy settings stored in job programs.

Disabling of bypass-tray in duplex copy

This program is used to disable the use of the bypass

tray when making duplex copies.

The bypass tray is often used to feed label sheets,

transparency film, and other special papers for which

two-sided copying is prohibited. If one of these special

papers enters the reversing unit, a misfeed or damage

to the unit may result. If special papers for which

two-sided copying is prohibited are often used, it is

recommended that you enable this program to prevent

feeding of special papers from the bypass tray into the

reversing unit during two-sided copying.

Disabling of auto paper selection

This program is used to disable the auto paper

selection function.

When this program is enabled, paper that is the same

size as the original placed on the document glass or in

the automatic document feeder is not automatically

selected.