Shimano DENDOUMARU 4000HP Instruction Manual - Page 6
Browse online or download pdf Instruction Manual for Fishing Equipment Shimano DENDOUMARU 4000HP. Shimano DENDOUMARU 4000HP 32 pages.
Print Page
Power Source & Cord
1
Handling precautions
Power
The power source is 12V DC (Direct Current). (The capacity for
usage is above 16,000mAh). Unspecified power source (such as
AC 100V for household, or 24V DC available on board the vessel)
cannot be used at all.
Absolutely do not use battery charger.
DC12V
AC100V
(16000mAh)
•
When using the power source on board, make sure that the
voltage is 12V DC (not directly from the vessel's battery, but use
DC-DC Converter, from 24V to 12V). And when the battery poles
are rusted, it may affect performance of reel, so remove the rust
first before using.
•
Use only battery that has been fully charged.
•
After fishing, to protect the battery life, charge up first before
storing. And before going out for fishing again, charge it up
again before using.
•
After using for a while, the charging capacity may deteriorate. In
that case, replace the battery only.
Cord
When connecting to battery, always use Shimano genuine cord.
Precautions: When using non-genuine cord, the reel may not
perform as expected. Besides that, do not misuse power cord.
If you step on it, fold it, or bend it, damage may occur.
6
C H A R G
E R
DC24V
2
Connection to battery
1
First connect the cord supplied to the battery.
As shown in the drawing, red clip to (+), and black clip to (-).
2
Next, connect reel to power cord.
The recess of power cord to the protruding reel power connec-
tor, then press in and fasten the screw.
For explanation purpose, the direction of
connector recess is facing the opposite side.