Shimano DENDOUMARU 4000HP Buku Petunjuk - Halaman 6

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Peralatan Memancing Shimano DENDOUMARU 4000HP. Shimano DENDOUMARU 4000HP 32 halaman.

Power Source & Cord

Handling precautions

Power

The power source is 12V DC (Direct Current). (The capacity for

usage is above 16,000mAh). Unspecified power source (such as

AC 100V for household, or 24V DC available on board the vessel)

cannot be used at all.

Absolutely do not use battery charger.

DC12V

AC100V

(16000mAh)

•

When using the power source on board, make sure that the

voltage is 12V DC (not directly from the vessel's battery, but use

DC-DC Converter, from 24V to 12V). And when the battery poles

are rusted, it may affect performance of reel, so remove the rust

first before using.

•

Use only battery that has been fully charged.

•

After fishing, to protect the battery life, charge up first before

storing. And before going out for fishing again, charge it up

again before using.

•

After using for a while, the charging capacity may deteriorate. In

that case, replace the battery only.

Cord

When connecting to battery, always use Shimano genuine cord.

Precautions: When using non-genuine cord, the reel may not

perform as expected. Besides that, do not misuse power cord.

If you step on it, fold it, or bend it, damage may occur.

C H A R G

E R

DC24V

Connection to battery

First connect the cord supplied to the battery.

As shown in the drawing, red clip to (+), and black clip to (-).

Next, connect reel to power cord.

The recess of power cord to the protruding reel power connec-

tor, then press in and fasten the screw.

For explanation purpose, the direction of

connector recess is facing the opposite side.