Shimano SG-8C20 Service Manual - Page 21
Browse online or download pdf Service Manual for Industrial Equipment Shimano SG-8C20. Shimano SG-8C20 36 pages. Inter-8 coaster hub
Also for Shimano SG-8C20: Technical Service Instruction (4 pages)
Print Page
Assembly of the INTER-8 coaster hub
1.
With the hub axle unit mount-
ed in a vice, align the two
teeth on the clutch unit with
the two notches in the hub
axle unit. Turn the clutch unit
clockwise until it is in its final
position as shown.
(Y-35P 98060)
2.
Install the return spring with
the largest coil downward.
The spring should sit in the
groove on the clutch unit,
shown as a blue line in the
picture. Be careful not to
install the return spring A
upside down.
3.
Assemble the driver unit by
aligning the more shallow
notch on the driver unit
with the wider tooth on the
clutch unit. Rotate the driver
counterclockwise to hold the
compressed spring in position.
(Y-34R 98050)
Clutch unit
Clutch unit
NOTE:
During the assembly procedures
coat all seals, gears and pawl
assemblies with a thin coat of
Nexus specific grease. Where
indicated by blue grease icon,
apply grease liberally.
(Y-041020800)
Return spring A
(Y-34R 21000)
NOTE:
Assemble the driver
unit while pushing
pawls B as shown in
the picture.
Set drive unit
while turn it
counterclock-
wise.
21