Digital Barriers EDGEVIS HD-IP250 Installation Manual - Page 2
Browse online or download pdf Installation Manual for DVR Digital Barriers EDGEVIS HD-IP250. Digital Barriers EDGEVIS HD-IP250 14 pages.
Print PageEDGEVIS HD-IP250 HARDWARE INSTALLATION
Introduction
Before proceeding with the installation and setup of your HD-IP250 unit, please ensure that you check the package
contents listed below, refer to the installation notes on the next page and consult the Quick Start Guide that was
supplied with your unit for step-by-step instructions on preparing hardware and software components.
To operate this device you will need to set up, or have access to, the following architecture:
HD-IP250
To proceed you must have access to an EdgeVis Server, with an account created for the encoder to use. If you do not
have an EdgeVis Server available refer to EdgeVis Server Quick Start Guide which will walk through the steps
required to install the server and create the necessary accounts required to proceed.
What is in the box?
EdgeVis encoder
Accessories
Printed materials
How do I configure the HD-IP250 unit?
After the introduction, there are three sections in this document that help you to configure your HD-IP250 unit:
Section 1
Section 2
Section 3
Appendix A
ISSUED: 10 NOVEMBER 2020
sends video to
EdgeVis Server
EdgeVis HD-IP250
AC/DC 12V power supply, mains power lead
Quick Start Guide
Basic operations of the unit
Powering the unit and connecting devices or drives to the HD-IP250
Configuring communications on the HD-IP250
Connecting to wired, Wi-Fi and cellular networks (including SIM card insertion)
Next steps...
With the HD-IP250 unpacked and wired, what are the steps required to set up the encoder?
Troubleshooting and frequently asked questions
Potential hardware issues that may be encountered with an HD-IP250
sends video to
EdgeVis Clients
PAGE 2