Digital Electronics PS3651A-T42S-24V Installation Manual - Page 12

Browse online or download pdf Installation Manual for Monitor Digital Electronics PS3651A-T42S-24V. Digital Electronics PS3651A-T42S-24V 17 pages.

Print Page

(3) Insert each fastener's hook into the slot

and tighten it with a screwdriver. Insert

the installation fasteners securely into

the insertion slot recess. There are eight

insertion slots.

Insertion Slot Recess

Hook the fastener

on the Recess,

Panel

Installation Fastener

PS-A

Hook

• Tightening the screws with too much

force can damage the PS-A unit.

• The necessary torque is 0.5N•m.

• Be sure to insert installation fasteners

in the recessed portion of an

installation fasteners hole. If the

fasteners are not correctly attached,

the PS-A unit may shift or fall out of the

panel.

Wiring

• To avoid an electric shock, prior to

connecting the PS-A unit's power cord

terminals to the power terminal block,

confirm that the PS-A unit's power

supply is completely turned OFF, via a

breaker, or similar unit.

Insertion

Slots

and secure the fastener

on the panel with a screw.

• Supplying a power voltage other than

that specified can damage the PS-A

and the power supply.

• Since the DC power supply Type has

no power ON/OFF switch, be sure to

attach a breaker-type switch to its

power cord.

• When the FG terminal is connected, be

sure the wire is grounded.

• When the FG terminal is connected, be

sure the wire is grounded. Not

grounding the PS-A unit will result in

excessive noise. Use your country's

applicable standard for grounding.

Power Cord Specifications

Use copper conductors only.

Power Cord

Diameter

Conductor

Type

Conductor

Length

If the Conductor's end (individual) wires are

not twisted correctly, the end wires may either

short against each other, or against an electrode.

Wiring

When connecting the power cord, use the

following items when performing wiring.

(Items are made by Phoenix Contact.)

Recommended

Driver

Recommended

Pin Terminals

0.75 to 2.5mm

(18 to 12 AWG)

Solid or Stranded Wire

10mm [0.39in.]

SZS 0.6x3.5 (1205053)

AI 0.75-10GY (3201288)

AI 1-10RD (3200182)

AI 1.5-10BK (3200195)

AI 2.5-12BU (3200962)