Siemens SINAMICS G120 Getting Started - Page 27

Browse online or download pdf Getting Started for Industrial Equipment Siemens SINAMICS G120. Siemens SINAMICS G120 30 pages. Using blocksize converters in marine applications
Also for Siemens SINAMICS G120: Getting Started (46 pages), Operating Instructions Manual (32 pages), Hardware Installation Instructions (2 pages), Installation Instructions And Owner's Manual (2 pages), Installation Instructions (2 pages), Installation Instructions (2 pages), Compact Operating Instructions (32 pages), Manual (42 pages), Getting Started (50 pages), Device Manual (34 pages), Quick Install Manual (2 pages), Application Description (50 pages), Compact Operating Instructions (2 pages), Manual (31 pages), Applications Manual (34 pages), Compact Operating Instructions (2 pages), Compact Operating Instructions (2 pages)

Print Page
Siemens SINAMICS G120 Getting Started
This selection performs in addition to disconnecting the PC form the inverter the
following steps:
: saves project on your PC
: saves drive settings on your PC (Upload)
: Saves data from inverter RAM to EEPROM
4.4

Factory reset

Description
With a factory reset a defined initial state of all of the inverter parameters can be re-
established.
To perform a factory reset with STARTER, the inverter must be in the online mode. If it
is offline, perform "connect to target system" (
The factory reset is performed in the following steps:
Select the drive unit in the navigation tree (
● Click the factory reset icon (
Note
When resetting the parameters to the factory setting, the communications memory
is re-initialized. This means that communications are interrupted for the time it takes
to perform the reset.
CU240E
Getting Started, 10/2007, A5E01301680B AA
)
)
).
Commissioning
27