Siemens SINAMICS G120 Manual - Page 13

Browse online or download pdf Manual for Industrial Equipment Siemens SINAMICS G120. Siemens SINAMICS G120 42 pages. Using blocksize converters in marine applications
Also for Siemens SINAMICS G120: Getting Started (46 pages), Operating Instructions Manual (32 pages), Getting Started (30 pages), Hardware Installation Instructions (2 pages), Installation Instructions And Owner's Manual (2 pages), Installation Instructions (2 pages), Installation Instructions (2 pages), Compact Operating Instructions (32 pages), Getting Started (50 pages), Device Manual (34 pages), Quick Install Manual (2 pages), Application Description (50 pages), Compact Operating Instructions (2 pages), Manual (31 pages), Applications Manual (34 pages), Compact Operating Instructions (2 pages), Compact Operating Instructions (2 pages)

Print Page

4 SINAMICS G120 Add-On Instructions

4.4.2

Schematic Ladder Representation

Figure 4-2 Vector Speed T352

4.4.3

Table 4-7 Input parameters

Vector_Speed_T352

ON_OFF1

OFF2

OFF3

RUN_SET_POINT

FAULT_RESET

RPM_SET_SPEED

SINAMICS G: Control of a G120 with an Allen-Bradley controller

(Compact/ ControlLogix with RSLogix 5000) via EtherNet/IP

Entry-ID: 82843076,

V4.0,

Instance Data

BOOL

REAL

09/2018

Drive Enable (ON/OFF1)

1 = Enable Drive

2 = Ramp down and disable drive

Coast Stop Command

0 = Off2 (Immediate disable)

1 = No OFF2 command

Fast Stop command

0 = OFF3 Fast ramp and disable drive

1 = No OFF3 command

Speed setpoint enable

0 = Setpoint disabled

1 = Setpoint enabled

Reset active drive faults

0 = No fault reset

1 = Reset fault(s) on rising edge

Speed setpoint in [rpm]