Epson 830p - PowerLite XGA LCD Projector Operation Manual - Page 33

Browse online or download pdf Operation Manual for Projector Epson 830p - PowerLite XGA LCD Projector. Epson 830p - PowerLite XGA LCD Projector 36 pages. Release of emp ns connection for windows & mac upgrade from v2.50 to v2.51
Also for Epson 830p - PowerLite XGA LCD Projector: User Manual (42 pages), Operation Manual (47 pages), Quick Setup (2 pages), Supplementary Manual (1 pages), User Manual (15 pages), Brochure & Specs (4 pages), Installation Manual (19 pages), Technical Brief (7 pages), Function Manual (5 pages), Product Support Bulletin (25 pages), Product Support Bulletin (22 pages), Product Support Bulletin (28 pages), Product Support Bulletin (41 pages), Product Support Bulletin (15 pages), Product Support Bulletin (22 pages), Specification Sheet (4 pages)

Print Page
Epson 830p - PowerLite XGA LCD Projector Operation Manual

An e-mail notifying the operator of a problem/warning/status is issued

If the projector experiences a problem or enters a status requiring attention,
an e-mail like that shown below is sent to the address specified for
"Recipient mail address".
If there is more than one problem, warning, or status, the corresponding
messages are output to separate lines.
Item
E-mail subject
[Display name displayed in "Grouping view" or
"Detail list view"] Projector status notification
Body
<Display name displayed in "Grouping view"
or "Detail list view"> has entered the following
status.
<Problem/warning/status message (Please see
the table below)>
The details contained in the e-mail message can consist of the following.
Message
Internal Error
See your User's Guide for more information.
Fan error
Sensor error
Lamp Cover Open
Lamp failure at power on
Lamp Error
High internal
temperature error
Low air flow error
Air filter air flow sensor
error
Details shown
Remedy
Message
High-temperature
See your User's Guide for more information.
warning
Replace Lamp
Replace Air Filter
No Air Filter
Low Air Flow
Air Flow Sensor Err.
Clean Air Filter Notice
No signal
No image signals are being received by the
projector. Check the connection status and
check that the power for the connected
equipment is turned on.
Other error
Stop using the projector, disconnect the
Supply System Error
power cable from the electrical outlet, and
(Ballast)
contact Epson.
Auto Iris Error
Network error (TCP
Check that the projector's power is turned on
connection error)
and the LAN cable is connected, and also
check that "Network Monitoring" is set to
"ON" or "Standby Mode" is set to "Network
ON".
Network error (ESC/
Check that the projector has been correctly
VP.net communication
connected to the network.
error)
Network error (monitor
Check the projector's Monitor Password.
password authentication
error)
Messages to inform that the projector has recovered from the error or
warning statuses are sent.
32
Remedy