Siemens WM**U series Installation & Operation Manual - Page 31
Browse online or download pdf Installation & Operation Manual for Washer Siemens WM**U series. Siemens WM**U series 40 pages.
Print Page
Faults
The spin cycle runs sev-
eral times.
The programme is taking
longer than usual.
The length of the pro-
gramme changes during
the wash cycle.
Residual water in the left-
hand compartment for
the care product.
Odours, stain formation in
the appliance.
Repeated, intensive foam-
ing.
Loud noises, vibrations
and appliance "move-
ment" during the spin
cycle.
The Touch-Display indica-
tor lights do not work
while the appliance is run-
ning.
There is detergent resi-
due on the laundry.
If you cannot rectify a fault yourself (after switching the appliance off and on again) or a repair is required:
Switch off the appliance and pull out the mains plug.
■
Turn off the tap and call customer services.
■
Cause/Remedy
Not a fault – the unbalanced load detection system is adjusting an imbalance.
Not a fault – the unbalanced load detection system is adjusting an imbal-
■
ance by repeatedly distributing the laundry.
Not a fault – the foam detection system is active – a rinse cycle has been
■
switched on.
Not a fault – the programme sequence is optimised for the specific washing
process. This may change the length of the programme shown on the Touch-
Display.
Not a fault – the effectiveness of the care product is not affected.
Run the ä Drum Clean 90 °C programme without laundry.
Add washing powder or a detergent containing bleach.
To prevent foaming, only use half the amount of detergent recommended
Note:
by the detergent manufacturer. Do not use detergents designed for woollens or
delicates.
Check your basic dosage and dosage strength settings.
■
If required, use a different liquid detergent.
■
Is the appliance aligned?
■
~ "Alignment" on page 37
Are the appliance's feet fixed? Secure the appliance's feet.
■
Have the transport locks been removed?
■
~ "Removing the transport locks" on page 34
Has there been a power failure?
■
Have the fuses blown? Reset/replace the fuses.
■
If the fault occurs repeatedly, call customer services.
■
Some phosphate-free detergents contain water-insoluble residue.
■
Select q Rinse/Spin 0 or brush the laundry after washing.
■
Faults and what to do about them
en
31