Siemens dishwasher Operating Instructions Manual - Page 6

Browse online or download pdf Operating Instructions Manual for Dishwasher Siemens dishwasher. Siemens dishwasher 28 pages. Dishwasher
Also for Siemens dishwasher: Instructions For Use Manual (29 pages), Operating Instructions Manual (30 pages), Operating Instructions Manual (30 pages), Operating Instructions Manual (30 pages), Operating Instructions Manual (28 pages), Operating Instructions Manual (26 pages), Instructions For Use Manual (28 pages), Instructions For Use Manual (26 pages), Instructions For Use Manual (28 pages), Instructions For Use Manual (32 pages), Instructions For Use Manual (28 pages), Instructions For Use Manual (34 pages), Instructions For Use Manual (34 pages), Instructions For Use Manual (28 pages), Instructions For Use Manual (34 pages), Instructions For Use Manual (26 pages), Operating Instructions Manual (40 pages), Instructions For Use Manual (31 pages), Instructions For Use Manual (40 pages), Operating Instructions Manual (24 pages), Operating Instructions Manual (28 pages)

Print Page
Siemens dishwasher Operating Instructions Manual
en

Water softening system

To ensure good washing results, the
dishwasher requires soft water, i.e.
containing low amounts of lime, otherwise
white limescale will be deposited on the
utensils and inner container.
Tap water above 9° Clarke must be
softened. The water is softened with salt
(regeneration salt) in the water softening
system of the dishwasher.
The setting and therefore the required
amount of salt depends on the degree of
hardness of your tap water (see table).

Water hardness table

:DWHU
+DUGQHVV
KDUGQHVV
UDQJH
YDOXH
ƒ&ODUNH
VRIW
VRIW
PHGLXP
PHGLXP
PHGLXP
KDUG
KDUG
KDUG
6
PPROO
6HW YDOXHâRQâ
WKHâPDFKLQH
¯
³
›
´
ž
‚
±
Å

Setting

The amount of salt dispensed can be set
from
to .
Sal is not required at the set value .
– Find out about the hardness
value of your tap water. Your water
utility company will help you with this.
– Set value can be found in the water
hardness table.
– Close the door.
– Rotate the programme selector 8
from the 12 o'clock position anti-
clockwise by one notch.
– Switch on main switch ( and hold
down for at least 3 sec.
The current set hardness value is
indicated on the digital display `
and the salt refill indicator P flashes
(set hardness value was set to level
at the factory).
To change the setting:
– Rotate programme selector 8.
You can select a set value between
and
according
to the hardness of your water.
– Switch off the main switch (
The chosen setting has now been
stored.