Cisco SPA300 Series User Manual - Page 31

Browse online or download pdf User Manual for IP Phone Cisco SPA300 Series. Cisco SPA300 Series 38 pages. Configure ring type
Also for Cisco SPA300 Series: User Manual (12 pages), Quick Reference Card (2 pages), Quick Reference Card (2 pages), Quick Start Manual (2 pages), Quick Start Manual (3 pages), Quick Start Manual (3 pages), Instruction Manual (3 pages), Manual (2 pages), Manual (2 pages), Quick User Manual (2 pages)

Print Page

Using Your Cisco SPA302D

Configuring Phone Settings

NOTE

STEP 1

STEP 2

STEP 3

STEP 4

Cisco SPA302D Mobility Enhanced Cordless Handset User Guide

•

Date and Time

•

Handset Settings

•

Update Software

•

Factory Reset

•

Phone Info

Configuring Network Settings

You can enter or modify the network settings on your handset. These settings

indicate the method that your handset and base station use to connect to the

Internet.

You should only change this setting if advised to do so by your phone system

administrator.

From the Settings menu, choose Network Settings.

Enter the PIN code (available from your phone system administrator). By default,

there is no PIN code. Press Confirm.

Press the Right and Left arrow buttons on the navigation keypad to scroll through

the available network settings and press Confirm to change the selected setting.

You can choose from the following settings:

•

DHCP (most common)—The Cisco SPA302D and the Cisco SPA232D

receive an IP address from the DHCP server on your network (typically, the

router or switch to which your hardware is connected).

•

Static IP—Choose this setting if you need the Cisco SPA302D to have an

assigned IP address that does not change. Enter the IP address, subnet

mask, gateway address and DNS server addresses.

•

PPPoE—Choose this setting if you have a Point-to-Point Protocol over

Ethernet connection to the Internet. Enter your username, password, and

service information for your Internet connection.

Press Confirm to save your changes.