Cisco SPA300 Series 사용자 설명서 - 페이지 31

{카테고리_이름} Cisco SPA300 Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco SPA300 Series 38 페이지. Configure ring type
Cisco SPA300 Series에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지), 빠른 참조 카드 (2 페이지), 빠른 참조 카드 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (3 페이지), 빠른 시작 매뉴얼 (3 페이지), 사용 설명서 (3 페이지), 매뉴얼 (2 페이지), 매뉴얼 (2 페이지), 빠른 사용 설명서 (2 페이지)

Using Your Cisco SPA302D

Configuring Phone Settings

NOTE

STEP 1

STEP 2

STEP 3

STEP 4

Cisco SPA302D Mobility Enhanced Cordless Handset User Guide

•

Date and Time

•

Handset Settings

•

Update Software

•

Factory Reset

•

Phone Info

Configuring Network Settings

You can enter or modify the network settings on your handset. These settings

indicate the method that your handset and base station use to connect to the

Internet.

You should only change this setting if advised to do so by your phone system

administrator.

From the Settings menu, choose Network Settings.

Enter the PIN code (available from your phone system administrator). By default,

there is no PIN code. Press Confirm.

Press the Right and Left arrow buttons on the navigation keypad to scroll through

the available network settings and press Confirm to change the selected setting.

You can choose from the following settings:

•

DHCP (most common)—The Cisco SPA302D and the Cisco SPA232D

receive an IP address from the DHCP server on your network (typically, the

router or switch to which your hardware is connected).

•

Static IP—Choose this setting if you need the Cisco SPA302D to have an

assigned IP address that does not change. Enter the IP address, subnet

mask, gateway address and DNS server addresses.

•

PPPoE—Choose this setting if you have a Point-to-Point Protocol over

Ethernet connection to the Internet. Enter your username, password, and

service information for your Internet connection.

Press Confirm to save your changes.