Cisco 12000 - Series Chassis Modular Expansion Base Replacement Instructions Manual - Page 4
Browse online or download pdf Replacement Instructions Manual for Network Router Cisco 12000 - Series Chassis Modular Expansion Base. Cisco 12000 - Series Chassis Modular Expansion Base 40 pages. Internet router line card failures
Also for Cisco 12000 - Series Chassis Modular Expansion Base: Datasheet (9 pages), Overview Manual (6 pages), Hardware Troubleshooting Manual (18 pages)
Print Page
GRP, PRP, and Line Card Memory Overview
Figure 1
SIMM socket on the GRP.
The two route memory DIMM sockets on the GRP, labeled U39 (route memory bank 1) and U42 (route
memory bank 2), respectively, enable you to configure route memory in desired increments ranging from
128 to 512 MB.
Note
Table 1
default route memory configuration is 128 MB. If the GRP is currently equipped with one 64-MB DIMM
in socket U39, you can upgrade memory by installing a second 64-MB DIMM in socket U42, or by
removing the existing 64-MB DIMM and replacing it with one 128-MB DIMM.
Figure 1
Bank 2
DRAM DIMMs
Bank 1
Cisco 12000 Series Router Memory Replacement Instructions
4
shows the locations of the processor memory DRAM DIMM sockets and the Flash memory
GRP route memory configurations of 512 MB are only compatible with Product Number
GRP-B=. Cisco IOS Release 12.0(19)S or 12.0(19)ST or later and ROMMON Release 11.2
(181) or later are also required.
lists the available route memory configurations and associated product numbers for the GRP. The
Memory Locations on the Cisco 12000 Series Router GRP
Backplane connector
PCMCIA slots
slot 0: bottom
slot 1: top
U42
U39
U17
Auxiliary port
Console port
(RJ-45 or MII)
Flash
SIMM
GIGABIT ROUTE PROCESSOR
Alphanumeric
LED displays
Ethernet
interface
78-4338-16