Cisco 3800 Series Configuring - Page 13
Browse online or download pdf Configuring for Network Router Cisco 3800 Series. Cisco 3800 Series 32 pages. Password recovery procedure
Also for Cisco 3800 Series: Datasheet (8 pages), Application Note (41 pages), Troubleshooting Manual (15 pages), Datasheet (20 pages), Quick Start Manual (40 pages), User Manual (7 pages)
Print Page
Configuring Radio Settings on an Access Point
Enabling and Disabling World Mode on an Access Point
Perform this task to configure the AP to support 802.11d world mode or Cisco legacy world mode.
When you enable world mode, the AP adds channel carrier set information to its beacon. Client devices
with world mode enabled receive the carrier set information and adjust their settings automatically. For
example, a client device used primarily in Japan could rely on world mode to adjust its channel and
power settings automatically when it travels to Italy and joins a network there. World mode is disabled
by default.
Aironet extensions must be enabled for world mode operation. Aironet extensions are enabled by default.
World mode is not supported on the 5-GHz radio.
Note
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
interface dot11Radio interface
Example:
Router(config)# interface dot11Radio 0/3/0
Step 4
world-mode {legacy | dot11d country-code code}
{indoor | outdoor | both}
Example:
Router(config-if)# world-mode legacy indoor
enable
configure terminal
interface dot11Radio interface
world-mode {legacy | dot11d country-code code} {indoor | outdoor | both}
end
copy running-config startup-config
How to Configure Radio Settings on an Access Point
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Enters global configuration mode.
Enters radio interface configuration mode.
The interface argument is in module/slot/port format,
•
except for the Cisco 800 series and Cisco 1800 series
fixed-configuration routers, where the interface
argument is either 0 or 1.
The 2.4-GHz radio is port 0, and the 5-GHz radio is
•
port 1.
Enables AP world mode operation.
The example enables Cisco legacy world mode and
•
specifies that the AP is indoors.
13