Cisco XR 12416 Repacking Manual - Page 24

Browse online or download pdf Repacking Manual for Network Router Cisco XR 12416. Cisco XR 12416 26 pages. Cisco systems router owner's manual
Also for Cisco XR 12416: Installation Manual (41 pages)

Print Page

Repackaging the Replaced Router Chassis

Step 7

Step 8

Step 9

Repackaging the Replaced Router Chassis

Note

Cisco XR 12416 and Cisco XR 12816 Router Chassis Installation Guide

A-24

To fasten the two U-shaped side panels together, use

reference and follow these steps.

Starting at one of the top holes on one narrow side panel, align the holes in

the inner and outer corrugated panels.

Open a plastic locking clip by pulling the wedge block out of the clip.

Insert the clip into the hole, then pivot the wedge block into the opening on

the body of the clip and push firmly until it snaps into place, spreading the

butterfly tabs and locking the inner and out side panels together.

Repeat steps

and

Repeat steps

through

Set the corrugated top cap on top of the container side panels and push it down.

Use a strapping machine to wrap two straps end-to-end and two straps side-to-side

over the top of the shipping container to secure it to the pallet.

Your router is now repackaged and ready to be transported. Use a forklift or pallet

jack to move the repackaged router.

This section describes how to repackage a defective chassis to return it to the

factory.

Because the packaging scheme for a bare chassis is very similar to the packaging

scheme for a fully-equipped router, the process for repackaging a bare chassis is

very similar to the process of packaging a fully-equipped router.

for the remaining holes on the narrow side panel.

for the opposite narrow side panel.

Appendix A

Repackaging the Router

Figure A-1 on page A-4

OL-17440-01

as a