Cisco 1262 Installation Manual - Page 3

Browse online or download pdf Installation Manual for Wireless Access Point Cisco 1262. Cisco 1262 5 pages.

Print Page

Installing a padlock (optional)

Use the security hasp on the adapter cable access

cover and a padlock (that you provide) to secure your

access point to the mounting plate. Compatible

padlocks are Master Lock models 120T or 121T. The

cable access cover on the mounting bracket covers the

cable bay area (including the power port, Ethernet port,

console port, and mode button) to prevent access.

Follow these instructions to install the padlock:

1. With the access point installed on the mounting

bracket, insert a padlock into the security hasp.

Note: If your access point is mounted to a hard

ceiling, the clearance between the mounting bracket

and the ceiling is small. Work slowly using both hands

to position and secure the lock into the mounting

bracket hasp.

2. Rotate the lock clockwise and align the bail with the

lock body.

3. Grasp the lock and push it into the bail to lock the

lock. See Figure 4.

Figure 4. Inserting the padlock into the security hasp

4. Rotate the padlock into the padlock area. See

Figure 5.

Figure 5. Rotating the padlock into the padlock area

Cisco 1262 Access Point Installation Manual

The Cisco 1262 Access Point has six antenna ports:

three labeled 2.4 GHz ANTENNA as shown in Figure 6

below; and three labeled 5 GHz ANTENNA as shown in

Error! Reference source not found. below.

Figure 6. Three antenna ports labeled 2.4 GHz ANTENNA

Figure 7. Three antenna ports labeled 5 GHz ANTENNA

Each port has a black rubber protective cap, as shown in

Figure 8 below.

Figure 8. Black protective caps shown on four ports

Unless instructed otherwise for your specific installation,

remove the three protective rubber caps from the access

point ports labeled 5 GHz ANTENNA.

1. Attach the three 802.11 antenna cables to the three

5 GHz access point ANTENNA ports.

2. If the wireless antenna is part number MSS-MISC-

ANT-4-240 and the DVR is a MobileView PENTA,

connect the fourth antenna cable to the DVRs GPS

port.