DigitaLinx DL-HD70LS-H2 Quick Install Manual - Page 5

Browse online or download pdf Quick Install Manual for Extender DigitaLinx DL-HD70LS-H2. DigitaLinx DL-HD70LS-H2 8 pages.

Print Page

1. Verify all components included with the extender set are present before installation.

2. If the extenders are going to be permanently mounted to a surface, attach the included mounting

brackets with the supplied screws.

3. Turn off power and disconnect the audio/video equipment by following the manufacturer's

instructions.

4. Connect Category 6 or greater twisted pair cable with RJ45 connectors between the DL-HD70LS-H2

transmitter and the receiver. TIA/EIA-568B straight-through wiring connections must be used with all

HDBaseT extenders.

5. Connect an HDMI cable and any desired IR control accessories between the display and the

DL-HD70LS-H2 receiver.

6. Connect an HDMI cable and any desired IR control accessories between the source and the

DL-HD70LS-H2 transmitter.

7. Connect the included power supply to the DL-HD70LS-H2 transmitter or receiver and lock the

power supply to the power connector by twisting the locking collar clockwise.

8. Power on attached audio/video devices.

Passing IR Signals:

The DL-HD70LS -H2 is capable of passing IR signals between 30 and 50 KHz. To prevent

damage to any of the electronics, the extenders should be powered off while inserting

or removing any IR components. Inserting an IR transmitter into the IR IN port may

damage the IR circuit for that extender.

IR OUT: The IR transmitter (IR emitter) must be plugged into the IR OUT port.

IR IN: The IR receiver (IR eye) must be plugged into the IR IN port.

To pass 3rd party IR system signals through the DL-HD70LS-H2, such as a control sys-

tem, connect the TS connector of the IR-AC coupling cable (provided) to the IR output

port of the control system and connect the TRS connector of the IR-AC cable to the IR

IN to either transmitter or receiver of the DL-HD70LS-H2

Connectivity Instructions

DL-HD70LS-H2 Quick Guide