Cisco Small Business WAP551 Quick Start Manual - Page 3
Browse online or download pdf Quick Start Manual for Wireless Access Point Cisco Small Business WAP551. Cisco Small Business WAP551 13 pages. Reboot and reset to factory default settings
Also for Cisco Small Business WAP551: Datasheet (8 pages), Review (6 pages), Quick Start Quide (13 pages), Brochure & Specs (4 pages), Manual (4 pages)
Print Page
Cisco WAP551 and WAP561 Wireless-N
2
Access Points Features
Front Panel
The front panel of the devices consists of three lights: Power, WLAN, and
LAN. For full descriptions of the colors of the lights and their indications,
see
"Verifying the Hardware
A Kensington lock slot is found under the lights.
Back Panel
The back panel of the devices has an RJ-45 Ethernet port. Use the
Ethernet port to power your device using PoE. It is an auto-sensing,
Gigabit Ethernet (802.3) port used to connect your WAP devices to
network devices, such as computers, routers, or switches. Cisco strongly
recommends using Category 5e or better cable for Gigabit
connectivity.
Side Panel
The side panel of the devices has a Reset button. See
Devices or Returning them to their Factory Default Settings"
information on the Reset button.
Default Settings
Parameter
Username
Password
LAN IP Address
Fallback LAN IP
Subnetwork Mask
If you are using a Cisco RV Series router, the default range for the DHCP
assigned address is from 192.168.1.100 to 192.168.1.254. Any device
connecting to the same LAN will be assigned an IP address in this range.
Cisco WAP551 and WAP561 Wireless-N Access Points
Installation".
Default Value
cisco
cisco
DHCP address assigned
by server
192.168.1.245
255.255.255.0
"Rebooting the
for
3