Cisco WAP361 Quick Start Manual - Page 13

Browse online or download pdf Quick Start Manual for Wireless Access Point Cisco WAP361. Cisco WAP361 17 pages. Reboot and reset to factory default settings
Also for Cisco WAP361: Manual (4 pages)

Print Page

If the Cisco WAP361 does not receive a DHCP response (there is no DHCP

server on your network) after 60 seconds, the Cisco WAP361 will fallback

to the following default static IP address: 192.168.1.245 and a default mask

of 255.255.255.0. To reach that IP address, be sure that your computer is

on the 192.168.1.xxx network.

Rebooting the Cisco WAP361 or Resetting

to Factory Defaults

To reboot your Cisco WAP361:

• If the Cisco WAP361 uses a power adapter, with the power on, use the

POWER button to reboot the device. The POWER button only functions

when the Cisco WAP361 uses a power adapter.

• If the power supply is PoE, unplug your Ethernet connection for three

seconds and plug it back in.

• With the power on, press the RESET button with an opened paper clip

for less than 10 seconds, or until the lights go off.

–

When all the lights go off, release the RESET button.

–

Release the RESET button as soon as the lights go off, or you will

restore the Cisco WAP361 to factory default settings and lose your

configurations.

To reset the Cisco WAP361 to factory default settings:

• With the power on, press and hold the RESET button with an opened

paper clip for more than 10 seconds.

–

All of the lights will go off.

–

Release the RESET button when the power light turns on.

Cisco WAP361 Quick Start Guide