Cisco Profile Series Installing Manual - Page 12

Browse online or download pdf Installing Manual for Conference System Cisco Profile Series. Cisco Profile Series 16 pages. Jbod on the 12g sas modular raid controller
Also for Cisco Profile Series: Getting Started Manual (41 pages), User Manual (44 pages), User Manual (7 pages), Getting Started Manual (35 pages), Quick Reference Manual (2 pages), Installation Manual (44 pages), Configuration Manual (13 pages), Installation Sheet (2 pages), Installation Manual (2 pages), Quick Start Manual (4 pages), Quick Start Manual (4 pages), Getting Started Manual (32 pages), Manual (16 pages), Getting Started Manual (42 pages), Getting Started Manual (46 pages)

Print Page
Cisco Profile Series Installing Manual
Figure 2-12
1
Step 5
Install the power switch lock, see the
the screws to a torque of 8 to 10 in-lb (0.9 to 1.1 N-m). Torque the hex standoff to the same torque.
Step 6
Connect the other end of the ground wire to a known reliable earth ground point at your site.
Step 7
If you are using this router in a vehicle, attach the ring terminal to the chassis using one of the screws
provided and the green or green and yellow striped wire. Connect the other end of the wire to the vehicle
ground.
After you install and properly ground the router, you can connect the power wiring, the LAN cables, and
the cables for administrative access as required for your installation.

Installing the Power Cord Retention Latch

The Cisco 800M Series ISR has a power cord retention mechanism as a accessory. It locks the power
cord to the router. When a user accidentally pulls on the power cord, the power cord will not come out
from the router.
This section describes how to install the power cord retention lock.
Place the power cord lock onto the power cord, as shown in
Step 1
and then pull the plug back to seat in the lock.
Figure 2-13
Cisco 800M Series Integrated Services Router Hardware Installation Guide
2-12
Chassis Ground Connection Using Ring Terminal
1
Ring terminal
Place the Power Cord Lock onto the Power Cord
"Mounting the DC Power Supply" section on page
Figure
Chapter 2
Installing the Router
2-14. Tighten
2-13. The cable slides into the slot