Cisco Profile Series Handbuch zur Installation - Seite 12

Blättern Sie online oder laden Sie pdf Handbuch zur Installation für Konferenz-System Cisco Profile Series herunter. Cisco Profile Series 16 Seiten. Jbod on the 12g sas modular raid controller
Auch für Cisco Profile Series: Handbuch "Erste Schritte (41 seiten), Benutzerhandbuch (44 seiten), Benutzerhandbuch (7 seiten), Handbuch "Erste Schritte (35 seiten), Kurzreferenz-Handbuch (2 seiten), Installationshandbuch (44 seiten), Konfigurationshandbuch (13 seiten), Installationsblatt (2 seiten), Installationshandbuch (2 seiten), Schnellstart-Handbuch (4 seiten), Schnellstart-Handbuch (4 seiten), Handbuch "Erste Schritte (32 seiten), Handbuch (16 seiten), Handbuch "Erste Schritte (42 seiten), Handbuch "Erste Schritte (46 seiten)

Figure 2-12

Step 5

Install the power switch lock, see the

the screws to a torque of 8 to 10 in-lb (0.9 to 1.1 N-m). Torque the hex standoff to the same torque.

Step 6

Connect the other end of the ground wire to a known reliable earth ground point at your site.

Step 7

If you are using this router in a vehicle, attach the ring terminal to the chassis using one of the screws

provided and the green or green and yellow striped wire. Connect the other end of the wire to the vehicle

ground.

After you install and properly ground the router, you can connect the power wiring, the LAN cables, and

the cables for administrative access as required for your installation.

Installing the Power Cord Retention Latch

The Cisco 800M Series ISR has a power cord retention mechanism as a accessory. It locks the power

cord to the router. When a user accidentally pulls on the power cord, the power cord will not come out

from the router.

This section describes how to install the power cord retention lock.

Place the power cord lock onto the power cord, as shown in

Step 1

and then pull the plug back to seat in the lock.

Figure 2-13

Cisco 800M Series Integrated Services Router Hardware Installation Guide

2-12

Chassis Ground Connection Using Ring Terminal

Ring terminal

Place the Power Cord Lock onto the Power Cord

"Mounting the DC Power Supply" section on page

Figure

Chapter 2

Installing the Router

2-14. Tighten

2-13. The cable slides into the slot