Cisco Profile Series Handbuch zur Installation - Seite 14

Blättern Sie online oder laden Sie pdf Handbuch zur Installation für Konferenz-System Cisco Profile Series herunter. Cisco Profile Series 16 Seiten. Jbod on the 12g sas modular raid controller
Auch für Cisco Profile Series: Handbuch "Erste Schritte (41 seiten), Benutzerhandbuch (44 seiten), Benutzerhandbuch (7 seiten), Handbuch "Erste Schritte (35 seiten), Kurzreferenz-Handbuch (2 seiten), Installationshandbuch (44 seiten), Konfigurationshandbuch (13 seiten), Installationsblatt (2 seiten), Installationshandbuch (2 seiten), Schnellstart-Handbuch (4 seiten), Schnellstart-Handbuch (4 seiten), Handbuch "Erste Schritte (32 seiten), Handbuch (16 seiten), Handbuch "Erste Schritte (42 seiten), Handbuch "Erste Schritte (46 seiten)

Mounting the DC Power Supply

Warning

Read the wall-mounting instructions carefully before beginning installation. Failure to use the

correct hardware or to follow the correct procedures could result in a hazardous situation to people

and damage to the system. Statement 378

The Cisco 800M ISR DC power supply may be mounted to a wall using four #6 pan- or round-head wood

screws for the mounting holes on the supply.

Each mounting screw must go into a wall stud (wood) or a wall anchor of the appropriate type for the

Caution

wall. Screws into drywall is not sufficient to support the DC power supply.

•

If the screws are not properly anchored, the strain of the DC supply cables could pull the router from the

Caution

wall.

To mount the DC power supply to the wall, follow these instructions:

Step 1

Install the four screws into the mounting holes on the DC power supply as shown in

being secured to the wall studs or wall anchors.

Cisco 800M Series Integrated Services Router Hardware Installation Guide

2-14

End of tabs

For attaching to a wall stud, the power supply requires #6 wood screws (round- or pan-head). The

screws must be long enough to penetrate and tap at least 0.75 inches (19.1 mm) into the supporting

wood or metal wall stud.

For hollow-wall mounting, the power supply requires the use of appropriate-sized wall anchors that

work with the drywall thickness the unit is to be installed in. Use hollow-wall anchors that support

using #6 screws and use #6 pan- or round-head screws to secure the power supply to the wall. Each

wall anchor should be rated for at least 30 lbs.

Chapter 2

Installing the Router

Figure

2-16, before