Cisco TelePresence IP VCR 2200 Series Getting Started - Page 6

Browse online or download pdf Getting Started for Conference System Cisco TelePresence IP VCR 2200 Series. Cisco TelePresence IP VCR 2200 Series 15 pages.

Print Page

Connecting the VCR

Before you start

IMPORTANT

information at http://www.cisco.com/go/telepresence/safety.

Step one: Connect power

Connect the power connector on the rear of the unit to the power supply using the

supplied power cable. (There is no On/Off switch.)

Step two: Connect to Ethernet Port A

Connect an Ethernet cable from Ethernet Port A to an Ethernet switch (rather than a

hub, to minimize interference from other devices on the network). The Ethernet

port is a 10/100/1000 Mbps auto-sensing connection.

Only connect to Ethernet Port B if you need to connect the VCR to a

second subnet.

Do not connect Ethernet Port A and Ethernet Port B to the same subnet.

: Before installing the VCR, you must read the safety

Connecting the VCR