Cisco TelePresence SX10 Manual - Page 9

Browse online or download pdf Manual for Conference System Cisco TelePresence SX10. Cisco TelePresence SX10 45 pages. In-room control on touch 10
Also for Cisco TelePresence SX10: Installation Manual (8 pages), User Manual (26 pages), Quick Manual (2 pages), User Manual (34 pages), User Manual (29 pages), Preliminary User Manual (9 pages), User Manual (38 pages), Installation Manual (8 pages), User Manual (2 pages), User Manual (37 pages), Manual (45 pages), Installation Manual (2 pages), User Manual (34 pages), User Manual (5 pages), User Manual (38 pages), User Manual (38 pages), Getting Started Manual (46 pages), Quick Manual (2 pages)

Print Page

Create the in-room control panel

Table of contents

Introduction

Start the design of the in-room control panel

If an in-room control panel was not automatically loaded when you launced the

Create a user interface

editor, choose one of these alternatives:

•

New

API for in-room control

•

Import > From file

to a local file on an earlier occasion, into the editor.

•

Import > From codec

Widgets

system into the editor. Not available in the offline editor.

All alternatives erase any unsaved data in the editor, but the existing in-room

Command reference

control panel on the video system is neither overwritten nor deleted until a new

panel is exported to the video system.

Troubleshooting

Tips and tricks

Examples

D15358.01 APRIL 2016

Collaboration Endpoint software

version 8.1

creates a blank in-room control panel in the editor.

loads an in-room control panel, which has been exported

loads the current in-room control panel from the video

Start or continue the design of an in-room control panel