Cisco TelePresence SX10 Getting Started Manual - Page 21

Browse online or download pdf Getting Started Manual for Conference System Cisco TelePresence SX10. Cisco TelePresence SX10 46 pages. In-room control on touch 10
Also for Cisco TelePresence SX10: Installation Manual (8 pages), User Manual (26 pages), Quick Manual (2 pages), User Manual (34 pages), User Manual (29 pages), Preliminary User Manual (9 pages), User Manual (38 pages), Installation Manual (8 pages), User Manual (2 pages), User Manual (37 pages), Manual (45 pages), Manual (45 pages), Installation Manual (2 pages), User Manual (34 pages), User Manual (5 pages), User Manual (38 pages), User Manual (38 pages), Quick Manual (2 pages)

Print Page

Cisco TelePresence SX10 Getting Started Manual

Cisco TelePresence Video Systems

Contents

Setting date, time and location

(When not set by a provisioning system)

When setting up your video conference system, you should

check that the date and time settings are correct. Among other

things this information is used to time stamp messages transmit-

ted to gatekeepers and other network elements.

The time and date is shown in the top right corner of the main

display. It takes a few moments before the time on the screen

changes after changing the setup.

Always save the new value when you change a setting

• Drop down list selection: Navigate to the correct value

and press the

( ) key to save, or press the left arrow

key

to leave without saving.

• Text entry in an input field: Enter the text, navigate to

Ok/Save

to save the change, or navigate to

to leave without saving; then press the

confirm.

Back to task overview

D14639.15 Video Systems Getting Started Guide TC7.2, OCTOBER 2014.

Introduction

User interfaces

1. Go to

Home > Settings > Date and

2. Select

24 hours

drop down list as you prefer.

3. Select Day.Month.Year,

in the

Date format

4. Select your time zone from the

5. Select Auto,

as you prefer.*

a. If you select Manual, also enter the

in the corresponding input field.

b. If you select

Month,

lists.

6. Press

Home

Cancel

( ) key to

* NTP mode:

Auto: The time is regularly updated using an NTP server. The NTP server

address is automatically obtained from the network (DHCP).

Manual: The time is regularly updated using an NTP server. You must

manually enter the NTP server address.

Off: You must set the time manually. The time is not updated automatically.

Configuration

time.

12 hours (am/pm)

in the

Time format

Month.Day.Year

Year.Month.Day

drop down list as you prefer.

Time zone

drop down list.

Manual

Off

in the

NTP mode

drop down list

NTP server

address

Off,

also select the correct value for Day,

Year

and

Time

in the corresponding drop down

(

) to exit.

Getting Started Guide

Appendices

Contacts