Cisco TelePresence SX20 Getting Started Manual - Page 17

Browse online or download pdf Getting Started Manual for Conference System Cisco TelePresence SX20. Cisco TelePresence SX20 41 pages. In-room control on touch 10
Also for Cisco TelePresence SX20: Quick Set (8 pages), Getting Started Manual (42 pages), Quick Reference Manual (2 pages), Quick Set (2 pages), Quick Reference Manual (2 pages), User Manual (34 pages), User Manual (29 pages), Troubleshooting Manual (37 pages), Regulatory Compliance And Safety Information Manual (9 pages), Setup Manual (8 pages), User Manual (38 pages), Installation Manual (2 pages), User Manual (2 pages), Quick Reference Manual (2 pages), User Manual (37 pages), Manual (45 pages), Manual (45 pages), Installation Sheet (2 pages), Installation Manual (2 pages), User Manual (34 pages), User Manual (5 pages), User Manual (38 pages), User Manual (38 pages), Getting Started Manual (42 pages), Reference Manual (8 pages), Getting Started Manual (46 pages)

Print Page

Cisco TelePresence Video Systems

Contents

Configuration using the remote control and on-screen menu*

Waking up the system

If there is no menu on screen, press

Home

control to show the menu.

If the system does not show a menu on screen:

• Make sure the monitor is connected and has been switched

on.

• Make sure the remote control has batteries installed.

• Make sure the system is switched on.

If the system has just been switched on, wait a few minutes to

allow the system to start up.

If there is still no menu on screen, make sure the monitor cable

is connected to the basic video output connector. If in doubt,

see the installation guide for your product.

* This section does not apply for EX Series and MX Series.

Back to task overview

D14639.12 Video Systems Getting Started Guide TC7.0, DECEMBER 2013.

Introduction

User interfaces

(

) on the remote

Confirguration

Configuration

Remote control and

on-screen menu

Getting Started Guide

Appendices

Contacts